Products

 

All of the Following Products suit Ford Mk2 Escort.

 

 

Product Features:

 

All products are precision reproductions manufactured in Australia from modern materials which resist cracking and fading.They are brand new. UV resistant.

Each component is hand made in small quantities.

The original components are considered wear items and previously almost impossible to source as new.

Care is taken to include the identical split lines and the exact injection point, just as Ford made the original components many years ago.

Very difficult to distinguish from the NOS Ford part.

Please note: Prices outside of Australia will vary from time to time according to international currency exchange rates.

We are currently specialising in the reproduction of small rubber components for Mk2 Escorts not previously available as replications.

Discounts apply for quantity bulk purchases.

Some delays to ship may be needed pending stocks in hand, production schedules, and material availabilities. If delays to ship are expected will be discussed when ordering.

 

 

Please click on the image for larger images.

 

Bonnet Bump Stops Height Adjustment.

These are the bump stops fitted to the extreme ends of the radiator support panel.

Sold as a set of two.

Price: AUD$16.00    (approx. GBP8.67)

Bonnet Bump Stops Front Guard.

These are fitted to the top of the front guards.

Sold as a set of four.

Price: AUD$35.00    (approx. GBP18.96)

Bonnet Bump Stop Centre Bonnet.

This is the Bonnet Bump Stop fitted to the top centre of the heater bubble.

Sold as a set of one.

Includes the expanding pin/clip.

Price: AUD$15.00    (approx. GBP8.23)

Handbrake Linkage/Backing Plate Dust Boot.

These are the dust seal rubbers fitted to the hand brake linkage to the rear axle backing plate.

They have been copied from a Ford NOS unused part, include the tiny Part Numbers. Ford P/N: 64276783 W18181 5

Please Note: These are available in two sizes. The smaller size is for the 8" diameter brakes, the larger for the 9" diameter brakes. Both sizes have the same Ford Part Number!

Gallery images show both versions. The only easily seen difference is the position of the part numbers.

The distinguishing size is the rectangular slot where the handbrake linkage goes through.

Size 1 for the 8" diameter brakes measures 15mm X 5mm

Size 2 for the 9" dimameter brakes measures 17mm X 5.5mm

When ordering please notify the size you require.

Sold as set of two.

Price: AUD$35.00    (approx. GBP19.19)

Speedo Cable/Bulkhead Grommet.

This is the grommet that the speedo cable runs through and is fitted to the bulkhead.

Sold as set of one.

Price: AUD$15.00    (approx. GBP8.23)

Bonnet Release Cable/Inner Guard Grommet.

This is the grommet that the bonnet release cable runs through and is fitted to the top of the drivers side inner guard.

Sold as set of one.

Price: AUD$15.00    (approx. GBP8.23)

Rear Shock Absorber Hats.

These are the rubber hats fitted to the top of the rear shock absorbers as seen from inside the boot.

Original Ford Part Number: 18198.

Sold as a set of two.

Price: AUD$24.00    (approx. GBP13.16)

Ford Escort Mk2 RS2000 Rear Bumper Side Extension Mould Dress Plugs. (Mk2 RS2000 Only)

These are the dress blanking caps/plugs that fit over the holes in the rear bumper bar side extension moulds.

Fitted to the rear guards of all Mk2 RS2000's.

The dress plugs are available in gloss or semi gloss finish pending customer requirements. Please advise your choice when ordering.

Sold as a set of four.

Price: AUD$24.00    (approx. GBP13.16)

Accelerator Pedal Pad.

Considered an extremely rare part to find new.

Original Ford Part Number: 75AB-98870-AB

The only alteration is we removed the FORD logo on the underside.

Reliably copied from a Ford NOS unused MK2 Escort Accelerator Pedal Pad

Sold as a set of one.

Price: AUD$31.00    (approx. GBP17.00)

Fuel Filler Neck Hose. (Australian built vehicles only)

Fuel Filler Neck to Under Boot Floor Fuel Tank.

This is the rubber fuel hose fitted between the fuel filler neck located behind the rear licence plate

and the under boot floor fuel tank for the Australian built vehicles only.

Sold as a set of one.

Price: AUD$15.00

Mk2 RS2000 Gear Knob 4 Speed.

A wear item previously almost impossible to source as new. Considered an extremely rare part.

The replication detail includes UNWORN (NEW) reticulated pattern on the outside of the gear knob.

Reliably copied from a Ford NOS unused RS2000 gear knob safely stored away since 1988.

Includes the identical split line and the exact injection point, just as Ford made the originals many years ago.

Sold as a set of one.

These will fit most vehicles with a gear lever with an M10 X 1.5mm pitch thread.

Price: AUD$75.50    (approx. GBP41.41)

Mk2 RS2000 Gear Knob 5 Speed.

For those people who have an Escort with the 5 speed gearbox conversion.

This is not a Ford component, however is considered an evolution of the Mk2 RS2000 4 speed gear knob.

It is an exact copy of the RS2000 4 speed gear knob, with the inclusion of the 5 speed H pattern.

Reliably copied from a Ford NOS unused RS2000 4 speed gear knob safely stored away since 1988.

Includes the identical split line and the exact injection point.

Sold as a set of one.

These will fit most vehicles with a gear lever with an M10 X 1.5mm pitch thread.

Price: AUD$75.50    (approx. GBP41.41)

Please contact if you are interested in other 5 speed H pattern configurations.

Main Wire Loom/Bulkhead Grommet.

This is the grommet where the main wiring loom runs through the bulkhead.

Note! The only modification we made was to increase the diameter of the

central hole from 14.0mm to 17.0mm. This is to assist sliding the grommet over the wide flat electrical

connectors and the wider sections of the wiring loom. Once fitted the modification is not noticeable.

Sold as a set of one.

Price: AUD$26.00    (approx. GBP14.26)

Steering Column/Bulkhead Grommet.

This is the grommet that the steering column runs through the bulkhead.

These are NOT the plain rubber plugs with an offset hole punched in them that are available

from the UK and being sold as a substitute for the same purpose.

Includes the identical split line and the exact injection point, and offset hole just as

Ford made the originals many years ago.

The only modification made was the removal of the FORD logo.

Sold as a set of one.

Price: AUD$26.00    (approx. GBP14.26)

RS Motorsport Steering Wheel Centre Pad.

RS Motorsport Finis Code 9053564

Fits RS Motorsport Steering Wheels:

- 3 Spoke (P/No H71AB3600BA)

- 4 Spoke (P/No H788AB3600AA)

Please Note: Does NOT fit the Mk2 Escort RS2000 steering wheel.

The replication detail includes UNWORN (NEW) reticulated pattern.

Sold as a set of one.

Price: AUD$75.50    (approx. GBP41.41)

European Mk2 RS2000 Steering Wheel Centre Pad.

Fitted by Ford to all European built Escort Mk2 RS models; RS2000, Mexico & RS1800 until February 1977.

Part Number H75AB 3K640 AA, FINIS CODE 1564469

Fits the 3 spoke Mk2 RS2000 flat steering wheel.

The replication detail includes UNWORN (NEW) reticulated pattern.

This is a nice upgrade for the Australian built Mk2 RS2000 to replace the standard Escort centre pad fitted by Ford.

Sold as a set of one.

Price: AUD$65.00    (approx. GBP35.65)

Rear Spoiler (Rubber) Mk2 RS2000, Mk2 RS Mexico and RS1800.

For further information please see documentation on photo gallery link.

Grade A. Price: AUD$380.00    (approx. GBP208.43)

Grade B. Price: AUD$220.00    (approx. GBP120.67)

Mk2 Escort Bell Housing Clutch Boot.

Fits to the gearbox bell housing to cover the clutch cable mechanism.

Ford Part Number 2AA7513-AA.

The replication includes the finely detailed Ford Part Number.

Sold as a set of one. Includes wire clip.

Price: AUD$38.00    (approx. GBP20.84)

Mk2 Escort Rear Valence Panel Grommet Kits.

These are the small grommets fitted to the rear valence panel.

Two kits are available.

Kit 1 includes:

- grommet rear lience plate illumination wiring harness

- grommet located behind rear licence plate

- grommet below drivers side reverse light.

- grommets located immediately adjacent rear bumper bar mounting points on rear guard.

Price: AUD$39.00    (approx. GBP21.39)

Kit 2 (for the Australian built vehicles with the fuel filler located behind the licence plate) includes:

- all the above grommets plus two rear licence plate frame bump stops.

Price: AUD$46.00   

RS2000 Oil Line/Bulkhead Grommet.

This is the grommet that the oil line runs through and is fitted to the bulkhead.

Sold as a set of one.

Price: AUD$16.00    (approx. GBP8.78)

Brake Booster Servo Rod/Bulkhead Grommet.

This is the grommet that the brake booster servo rod runs through the bulkhead.

Sold as a set of one.

Price: AUD$28.00    (approx. GBP15.36)

RS2000 Aluminium Bellhousing Grommet.

Suits European built RS2000's with the aluminium bellhousing.

Does not suit the Australian built RS2000's.

Sold as a set of one.

Price: AUD$16.00    (approx. GBP8.78)

RS2000 Scheel Seat Tilt Forward Lever.

Suits the Scheel seat with the Tilt Forward Lever located half way up the side of the seat.

Sold as a set of one.

Price: AUD$25.00    (approx. GBP13.71)

RS2000 Scheel Seat Tilt Forward Lever Bezel.

Suits the Scheel seat with the Tilt Forward Lever located half way up the side of the seat.

Sold as a set of one.

Price: AUD$17.00    (approx. GBP9.32)

Boot Lid Bump Stops.

These are fitted to the underside rear corners of the boot lid.

Sold as a set of two.

Price: AUD$18.00    (approx. GBP9.87)

RS2000 Flat 3 Spoke Steering Wheel.

Fitted to all Mk2 RS2000's, Australian built Rally Pack and special build Capri.

For further information please see documentation on photo gallery link.

Sold as one.

Price: AUD$485.00      

Tail Light Seal.

Fits around the tail light assembly.

Exact copy of a NOS unused Altissimo seal.

Part Number 36.6088.

Other aftermarket tail light seals are available however these are the closest to the original Ford seals.

Identical size and softness.

Sold as pair.

Price: AUD$75.00    (approx. GBP40.92)

Boot Floor/Shackle Bolt Access Grommet.

Fitted to bodywork inside boot floor to permit access to rear suspension shackle bolt.

The grommet in the photo is an original Ford grommet and is being used for reference purposes only.

Sold as one.

Price: AUD$16.00    (approx. GBP8.73)

Bonnet Stay Grommet.

Fitted to top radiator support panel. Bonnet Stay Rod hinges through the grommet.

Sold as one.

Price: AUD$8.00    (approx. GBP4.73)

Windsreen Wiper Arm Grommet.

Fitted to the wiper pivot shaft.

Clips over the wiper arm nut.

Sold as one pair.

Price: AUD$25.00    (approx. GBP14.75)

Blinker Cable/Inner Guard Grommet.

Fitted to the inner guard. The blinker cable runs through the grommet.

Sold as one pair.

Price: AUD$16.00    (approx. GBP9.44)

Headlight Cable/Inner Guard Grommet.

Fitted to the inner guard. The headlight cable runs through the grommet.

Sold as one pair.

Full restoration of the RS2000 will require two pairs. The second pair is fitted to the RS2000 headlight brackets.

Price: AUD$20.00 pair   (approx. GBP11.80)

Sun Visor Grommet.

Fitted to the inner pivot points of the sunvisors.

Sold as one pair.

Price: AUD$8.00    (approx. GBP4.73)

 

 

 

 


Last Revised: March 21, 2017.
Copyright 2010-17. Peter Lytton. All Rights Reserved.